@n480s
-
Steve Bauman and
SANDRO N STRIMER are now friends 7 years, 11 months ago
-
John Secord and
-
John Secord and
Richard E Russell are now friends 7 years, 11 months ago -
Steve Bauman and
Karen Wade are now friends 7 years, 11 months ago -
John Secord and
Karen Wade are now friends 7 years, 11 months ago -
Becky Jones and
Karen Wade are now friends 7 years, 11 months ago -
Becky Jones and
John Secord are now friends 7 years, 11 months ago
-
John Lyon replied to the topic Window and windshield 200D in the forum Airframe – Meyers 200 8 years ago
Back in the Olden Days (1993), Don Petty sent 200D windows, for making molds, to Aircraft Windshields, 10871 Kyle Street, Los Alamitos CA 90720, Tel 562-430-8108. It was then, and is now, run by Judy Gallo, and has been in business for 50 years. That was a long time ago, and who knows if they can do anything now, but it is worth a try if Cee…[Read more]
-
John Secord and
Jay McLeod are now friends 8 years ago -
John Lyon replied to the topic hydraulic pressure in the forum Hydraulic System – Meyers 200 8 years ago
The whole spool valve was a vendor part, custom manufactured for Meyers. I would take the spring to a large dealer and see if they can match it. Century Spring Corp?
-
John Secord and
Barry Sims are now friends 8 years ago
-
Jamon Pruitt replied to the topic hydraulic pressure in the forum Hydraulic System – Meyers 200 8 years ago
Make sure your pump is good also could be loss of pressure from worn seals in the pump the spring will usually compress and coil bind with lots of shims “washers” and pressure will go up , probably to high ouch!
-
Mark Jensen started the topic hydraulic pressure in the forum Hydraulic System – Meyers 200 8 years ago
Does anyone know of a source for the spring that regulates hydraulic pressure(part number: D65B046-5)?
This spring applies pressure to a small plastic ball and mine has weakened and been shimmed with washers as much as possible. It now needs to be replaced. My mechanic was able to get the plastic ball from Joan Diver. It had to be replaced as…[Read more] -
Mark Jensen replied to the topic Introduction and advice needed in the forum General- Meyers 200 8 years ago
Hi Thomas,
I replaced all the glass on my 200 in 2001. Last month, I replaced the small vent window. The glass is available from Cee Baileys Aircraft Plastics. The web site is http://www.ceebaileys.com. They are currently listing the rear window for $390.00. Hope that helps.
Mark Jensen
-
John Secord and
Mark Young are now friends 8 years ago
-
John Secord and
nelson harding are now friends 8 years ago
-
John Secord wrote a new post 8 years ago
Reprint from EAA Vintage Airplane 2015 – Click here for PDF
GREAT READ!
-
John Secord and
Kent Aitchison are now friends 8 years ago
-
John Secord and
Hinrik Hjaltason are now friends 8 years ago -
John Secord and
Wes Knettle are now friends 8 years ago
- Load More
