-
Jamon Pruitt changed their profile picture 8 years, 4 months ago
-
Steve Bauman and
SANDRO N STRIMER are now friends 8 years, 4 months ago
-
John Secord and
-
John Secord and
Richard E Russell are now friends 8 years, 4 months ago -
Steve Bauman and
Karen Wade are now friends 8 years, 4 months ago -
John Secord and
Karen Wade are now friends 8 years, 4 months ago -
Becky Jones and
Karen Wade are now friends 8 years, 4 months ago -
Becky Jones and
John Secord are now friends 8 years, 4 months ago
-
Ed Pulliam replied to the topic Window and windshield 200D in the forum Airframe – Meyers 200 8 years, 4 months ago
John, on another matter-can you take a picture of the vent and post you mentioned on the hat shelf?
Much obliged.
-
greg grouleff started the topic Meyers Fly-In in the forum Meyers 200 8 years, 5 months ago
Saturday Oct 7th Harris Ranch
-
John Secord and
Jay McLeod are now friends 8 years, 5 months ago -
John Secord and
Barry Sims are now friends 8 years, 5 months ago
-
Thomas Kube replied to the topic Introduction and advice needed in the forum General- Meyers 200 8 years, 5 months ago
Thank you for the information. The crack has been drilled and I am watching it.
I am in the progress of talking to some specialists for having the the plane repainted.Will keep you informed.
Thomas
-
Jamon Pruitt replied to the topic hydraulic pressure in the forum Hydraulic System – Meyers 200 8 years, 5 months ago
Make sure your pump is good also could be loss of pressure from worn seals in the pump the spring will usually compress and coil bind with lots of shims “washers” and pressure will go up , probably to high ouch!
-
Ed Pulliam replied to the topic Introduction and advice needed in the forum General- Meyers 200 8 years, 5 months ago
Thomas, I replaced all except windshield in 2012 and also used Cee Bailey’s. We have heard they have been hard to get of late, but Mark is right, that’s the place to start.
Assume the crack has been stop-drilled for now?
-
Mark Jensen started the topic hydraulic pressure in the forum Hydraulic System – Meyers 200 8 years, 5 months ago
Does anyone know of a source for the spring that regulates hydraulic pressure(part number: D65B046-5)?
This spring applies pressure to a small plastic ball and mine has weakened and been shimmed with washers as much as possible. It now needs to be replaced. My mechanic was able to get the plastic ball from Joan Diver. It had to be replaced as…[Read more] -
Mark Jensen replied to the topic Introduction and advice needed in the forum General- Meyers 200 8 years, 5 months ago
Hi Thomas,
I replaced all the glass on my 200 in 2001. Last month, I replaced the small vent window. The glass is available from Cee Baileys Aircraft Plastics. The web site is http://www.ceebaileys.com. They are currently listing the rear window for $390.00. Hope that helps.
Mark Jensen
-
John Secord and
Mark Young are now friends 8 years, 5 months ago
-
John Secord and
nelson harding are now friends 8 years, 5 months ago
-
John Secord wrote a new post 8 years, 5 months ago
Reprint from EAA Vintage Airplane 2015 – Click here for PDF
GREAT READ!
- Load More
