@sandrostrimer
-
Steve Bauman and
Mike Hofman are now friends 9 years, 4 months ago
-
Steve Bauman and
Becky Jones are now friends 9 years, 4 months ago
-
Steve Bauman and
Ross Warner are now friends 9 years, 4 months ago
-
Steve Bauman and
Joe Field are now friends 9 years, 4 months ago
-
Steve Bauman and
Kevin McGinty are now friends 9 years, 4 months ago
-
Steve Bauman and
Donald Riggs are now friends 9 years, 4 months ago
-
Steve Bauman and
Kent Aitchison are now friends 9 years, 4 months ago
-
Steve Bauman and
Jay Herrin are now friends 9 years, 4 months ago
-
Steve Bauman and
Barry Sims are now friends 9 years, 4 months ago
-
Steve Bauman and
nelson harding are now friends 9 years, 4 months ago
-
Steve Bauman and
Jeffrey Wheeler are now friends 9 years, 4 months ago
-
Steve Bauman and
Thomas A. Bailey are now friends 9 years, 4 months ago
-
Steve Bauman and
Hugh Mattern are now friends 9 years, 4 months ago
-
Steve Bauman and
Matthew Kline are now friends 9 years, 4 months ago
-
Steve Bauman and
Phil W. Hart are now friends 9 years, 4 months ago
-
Steve Bauman and
Anthony Wood are now friends 9 years, 4 months ago
-
Steve Bauman and
Bob Matlock are now friends 9 years, 5 months ago
-
Steve Bauman and
John Lyon are now friends 9 years, 5 months ago
-
Steve Bauman and
Dan McLeod are now friends 9 years, 5 months ago -
John Secord replied to the topic Restoration / Rebuilding – Meyers 200 in the forum Meyers 200 9 years, 5 months ago
Ed,
To install the new seals do the following:
1. Take 1300 or 1300L glue and thin with MEK or Acetone to a chicken broth like consistency.
2. Brush with acid brush the contact surfaces of both the seal and airframe and let dry. Do this 3 times.
3. Measure and cut the correct amount of seal and mark the leading edge end.
4. With an acid…[Read more] - Load More
