Joe Martony

gary hays and Joe Martony are now friends 2 years, 11 months ago
Dean Siracusa and Joe Martony are now friends 2 years, 11 months ago
Joe Martony replied to the topic Picking up my “new” 200D in the forum General- Meyers 200 4 years, 1 month ago

Welcome, Brent. I know your plane – it was one of three in the Phoenix metro. We fly high for cross country out here and the 200D can really make time on the descents. I’m often mistaken for a twin by unfamiliar ATC. My approach:landing habits are the same as Tom T. above. I have reliably flight planned for 200mph true. Fly the plane, but baby t…[Read more]
Steve Bauman and Joe Martony are now friends 4 years, 10 months ago
Joe Martony changed their profile picture 4 years, 10 months ago
Joe Martony changed their profile picture 4 years, 10 months ago
Joe Martony started the topic 4 Point Harnesses – Front Seats? in the forum Interiors – Meyers 200 4 years, 10 months ago

Is anyone aware of the possibility/vendor for 4-point harnesses for the standard front seats? Please advise.

Joe Martony
N2998T
SN 371
Joe Martony replied to the topic Pilot looking for information on 200d in the forum General- Meyers 200 5 years, 3 months ago

Greg,

I have a 200D with stock seats. If flown with passengers your height. They are not obstructed when I allow them on the controls, but their knees can get in my way (yoke, throttle, trim) when I am flying and they are flat footed. I don’t believe headroom will be an issue for you. Getting in and out without pulling down hard on the door is…[Read more]
Joe Martony replied to the topic in the forum Joe Martony 8 years, 3 months ago

Dean,

If you don’t hear from Don Petty in this forum, I’d give him a call. I’m sure he has dealt with this at some point. He knows of you through Jim Jellison.

He’s at 602.689.9414

Joe Martony
N2998T
Joe Martony started the topic in the forum Light Weight Electrical Power for your OTW 8 years, 6 months ago

I’m told there is a recommended modification for the M200 that pulls the throttle to full open if the throttle cable breaks. Does anyone have the specs, parts list and technical drawing for the modification? Thanks, Joe Martony N2998T
Joe Martony became a registered member 8 years, 7 months ago