Friends – Activity – nelson harding – Meyers Aircraft Owners Association

Tom Thibodeau replied to the topic tail wheel boots? in the forum Airframe – Meyers OTW 5 years, 5 months ago

DIck,

Did you get your boot?

R, Tom
Tom Thibodeau replied to the topic Noise certificate in the forum Meyers 200 5 years, 5 months ago

Thomas,

I’m not familiar with a noise certificate being issued for the M200, but Marv Rogge had to complete noise testing when he installed the IO-550 with a 2 bladed prop on his aircraft. He or Steve Bauman may be able to answer if a “stock” certificate exists.

R, Tom
Tom Thibodeau replied to the topic Conversation in the forum Meyers 200 5 years, 5 months ago

Mark,

Sounds like your elevator trim is now correctly rigged. It should require 4 half turns (2 full turns) from full nose down to set at take-off position.

VR, Tom
Karen Wade wrote a new post 5 years, 5 months ago

It is with great sorrow that I report from California that Mr. Al Grouleff has passed away. Al was a long time Meyers 200 owner.

A bit of background information for the Meyers members who never had the
John Secord and Andy Nixon are now friends 5 years, 6 months ago
Tom Thibodeau and Hugh Mattern are now friends 5 years, 7 months ago
John Secord and Hugh Mattern are now friends 5 years, 7 months ago
Ashley Wade replied to the topic Original paint schemes in the forum Restoration / Rebuilding – Meyers OTW 5 years, 7 months ago

And sorry… I see I put Allclad not Alclad. Would mess you up if you’re searching.
Ashley Wade replied to the topic Original paint schemes in the forum Restoration / Rebuilding – Meyers OTW 5 years, 7 months ago

I am one of the newest to the OTW’s. Sir John Lyons that posted above is one of the most venerable, having owned an OTW and a 200 for many years. His suggestion about the Betzold family is perfect. Many would probably like to see Fred, Dan or Linda’s response, so please post back here. The three of them are members. To contact them click on…[Read more]
John Secord and Jim Abbott are now friends 5 years, 7 months ago
Tom Thibodeau replied to the topic Conversation in the forum Meyers 200 5 years, 8 months ago

Hi Ed,

I typically fly a little slower than most, but 100 mph on DW, 90 mph on base, and crossing the fence (just short of threshold at 85 mph works fine for me. I carry a little bit of power into the flare, and roll it off as the nose comes up. You don’t want to try to flare at 80 mph without any throttle, as it will sink through to a c…[Read more]
Tom Thibodeau replied to the topic 4 Point Harnesses – Front Seats? in the forum Interiors – Meyers 200 5 years, 8 months ago

Does anyone have an approved 337 for a 4-point harness?

R, Tom
Dean Siracusa replied to the topic AC 23-27 in the forum Meyers 200 5 years, 9 months ago

That’s very helpful! Thanks!
Dean Siracusa replied to the topic 4 Point Harnesses – Front Seats? in the forum Interiors – Meyers 200 5 years, 9 months ago

It wouldn’t be difficult to install them. There’s a steel hoop that goes over you, right in between the two side windows. You’d just have to cut into your roof liner.
Hugh Mattern started the topic AC 23-27 in the forum Meyers 200 5 years, 9 months ago

This AC provides guidance for substantiating parts or materials substitutions to maintain the safety of old or out-of-production GA aircraft, or other GA aircraft where the parts or materials are either difficult or impossible to obtain.
This AC applies to small aircraft type certificated before January 1, 1980,
Karen Wade wrote a new post 5 years, 9 months ago

The 2020 Meyers Aircraft Owners Association Fly-In has been set for September 9-13 at KSEZ in Sedona, Arizona as voted on during the 2019 Fly-In. This spectacular airport is one of the most scenic in the c
Ashley Wade started the topic Turn & Bank Service in the forum Avionics – Meyers OTW 5 years, 10 months ago

OTW #40 has an A-11 military type turn and bank in each of the cockpits, one of which is inop. There is a port on the side for oil. Does this oil ever require servicing? I could not find a maintenance manual for the instrument online. Wondering if I can resurrect the inop and also keep the functional one going.

Thanks Meyers brain trust,

Ashley
Ashley Wade joined the group Meyers 200 Group 5 years, 10 months ago
Ashley Wade replied to the topic Actuator Seals in the forum Hydraulic System – Meyers 200 5 years, 10 months ago

Hey Tom! Hope all is well at Honeapath. My A&P did the same as Ed’s and it has worked flawlessly for 4 years. The prior owner and I were plagued by our step. At one point before I purchased the plane the step actuator was disconnected and the door sealed up. That A&P recommended that it not be repaired. I bought the plane with the step inop.…[Read more]
Tom Thibodeau replied to the topic Actuator Seals in the forum Hydraulic System – Meyers 200 5 years, 10 months ago

Robert,

I do have the part numbers and quantities required and multiple extra seals since I was sent a duplicate order. However, I am currently on an extended work trip and do not have access to my data or parts at this time. If you are able to wait until mid-March, I will send you a complete set of seals (or just the part numbers) at no cost.…[Read more]
- Robert Whitfield replied 5 years, 10 months ago
  
  That would be great, let me know when you return from your trip.
Load More