Tom Thibodeau

Gary,

The high pressure seal double seal I mentioned above is actually called an O-ring loaded U-cup seal. It is a harder rubber up with a softer O-ring inserted to push the cup against the shaft. The McMaster part number is 9505K15. I believe this is the seal that was in my flap selector and gear valves, but the harder rubber cup was…[Read more]

Gary,

Here are the O-ring part numbers for each of the M200 gear and the flap actuators:

3 each AN6227B-17 (MS28775-212)
1 each AN6227B-10 (MS28775-112)

The flap and landing gear selector valve use the following seals
2 each MS2775-117
1 each 1161N52-204 . (They also have a reinforced high pressure double O-ring type seal, but it is a harder…[Read more]

Gary,
I am currently on vacation and won’t be at my hangar until Labor Day weekend. I sent Robert Whitfield a complete set of seals, so he should have the part numbers. All are common O-rings available thru Aircraft Spruce, except the internal gear handle valve and flap selector valve. I found a compatible seal at McMaster Carr that is working f…[Read more]

Ed,

I’ve been told they may be rechromed without creating any issues. Please contact Ross Warner to see about finding new old stock parts. He may be able to point you to someone who knows where to find them if you decide to go that route.

VR, Tom

Ray,

So very happy to hear the damage was minimal given your scenario. Thank you for the additional information. I’m guessing the strut extended slightly once the gear was in the well to force the tire against the bail and cause it to bind. A very unusual situation to be certain.

You did an excellent 2 wheel landing and had a great outcome.…[Read more]

One additional tidbit…

A broken gear handle Uplock cable will be apparent because without the Uplock released, the gear UP red light will stay illuminated. Basically one red, two green would indicate the Uplock did not release on the gear indicating red. Instead of trying to find which cable to pull, raise the gear by putting the gear handle i…[Read more]

Ray,

So sorry to hear about your gear extension issues with 489C. As you are aware (but others may not be), your aircraft has a different gear indicating system than other M200s. 489C has a transit lights, where stock aircraft have UP (red) and DOWN (green) lights.

The Gear system of the M200 is quite simple: an engine driven hydraulic pump…[Read more]

Robert,

How is the strut rebuild progressing? Need any assistance?

VR, Tom
N2919T

Ashley,

This is certainly amazing news!!! The G500 is a very capable unit and should provide years of reliable service for you and other M200 drivers. Sure would fit well into my Garmin stack …

VR, Tom
N2919T

Stefano,

Where do you visit in FL? We have several owners in the state that may be able to assist with your quest…

VR, Tom

James,

Welcome to the Meyers website. You’ll quickly discover most Meyers owners are very proud of their aircraft. These machines are members of their families, and tend to stay with their caretakers for many years. We’ve cherished N2919T for 21 years, and acquired it from a gentleman and his wife who cared for it for nearly 30 years. The air…[Read more]

Robert,
To clarify, each strut requires 3 seals as listed. If you are able to disassemble one strut, you can verify the dimensions prior to ordering.

VR, Tom

Robert,

My notes from Bill Perry show:
2ea AN6230B-4 (MS28775-226)
1ea AN6227B-30 (MS28775-327)
For all 3 gear struts.

All are available at Aircraft Spruce.

VR, Tom Thibodeau
N2919T

Welcome Doug!

As you may have noticed, we are passionate about our planes and enjoy the time we are able to put into preserving the fleet. Several have been upgraded to the IO-550, which is an amazing enhancement to the original design. Others have spent substantial resources on upgrading their avionics to make these fast cross country machines…[Read more]