Friends – Activity – Dan McLeod – Meyers Aircraft Owners Association

Joseph Gibbons became a registered member 5 years, 4 months ago
Joseph Gibbons's profile was updated 5 years, 4 months ago
Mark Jensen replied to the topic Conversation in the forum Meyers 200 5 years, 4 months ago

I have adjusted the half turns slightly to get the pitch contlol pressure I like for take off and initial climb.
Mark Jensen replied to the topic Conversation in the forum Meyers 200 5 years, 4 months ago

Prior to take off, my partner would rotate the elevator trim nob full nose down and then back eight half turns. I have recently had the elevator trim reworked and adjusted according to specks. I now rotate full nose down and then back four half turns for take off. This adjustes the gauge where it should be for take off and is a little more…[Read more]
Tom Thibodeau replied to the topic Conversation in the forum Meyers 200 5 years, 5 months ago

Hi Ed,

I typically fly a little slower than most, but 100 mph on DW, 90 mph on base, and crossing the fence (just short of threshold at 85 mph works fine for me. I carry a little bit of power into the flare, and roll it off as the nose comes up. You don’t want to try to flare at 80 mph without any throttle, as it will sink through to a c…[Read more]
Tom Thibodeau replied to the topic 4 Point Harnesses – Front Seats? in the forum Interiors – Meyers 200 5 years, 6 months ago

Does anyone have an approved 337 for a 4-point harness?

R, Tom
Dean Siracusa replied to the topic AC 23-27 in the forum Meyers 200 5 years, 6 months ago

That’s very helpful! Thanks!
Dean Siracusa replied to the topic 4 Point Harnesses – Front Seats? in the forum Interiors – Meyers 200 5 years, 6 months ago

It wouldn’t be difficult to install them. There’s a steel hoop that goes over you, right in between the two side windows. You’d just have to cut into your roof liner.
Hugh Mattern started the topic AC 23-27 in the forum Meyers 200 5 years, 6 months ago

This AC provides guidance for substantiating parts or materials substitutions to maintain the safety of old or out-of-production GA aircraft, or other GA aircraft where the parts or materials are either difficult or impossible to obtain.
This AC applies to small aircraft type certificated before January 1, 1980,
Karen Wade wrote a new post 5 years, 6 months ago

The 2020 Meyers Aircraft Owners Association Fly-In has been set for September 9-13 at KSEZ in Sedona, Arizona as voted on during the 2019 Fly-In. This spectacular airport is one of the most scenic in the c
Tom Thibodeau replied to the topic Actuator Seals in the forum Hydraulic System – Meyers 200 5 years, 7 months ago

Robert,

I do have the part numbers and quantities required and multiple extra seals since I was sent a duplicate order. However, I am currently on an extended work trip and do not have access to my data or parts at this time. If you are able to wait until mid-March, I will send you a complete set of seals (or just the part numbers) at no cost.…[Read more]
- Robert Whitfield replied 5 years, 7 months ago
  
  That would be great, let me know when you return from your trip.
Kent Aitchison and Dan Betzoldt are now friends 5 years, 7 months ago
Kent Aitchison and nelson harding are now friends 5 years, 7 months ago
Tom Thibodeau and Ashley Wade are now friends 5 years, 7 months ago
Kent Aitchison and Ashley Wade are now friends 5 years, 7 months ago
Steve Bauman and Joe Martony are now friends 5 years, 8 months ago
Dean Siracusa replied to the topic Rotating Beacon on a Meyers 200 in the forum Meyers 200 5 years, 8 months ago

The ones that I know about all seemed to have the original cap cut down and re-glassed.
Mark Jensen and Hinrik Hjaltason are now friends 5 years, 10 months ago
Tom Thibodeau and Hinrik Hjaltason are now friends 5 years, 10 months ago
Mark Jensen and Steve Freeman are now friends 5 years, 11 months ago
Load More