Ross Warner

Looking for parts list for nose gear assembly for N200D anyone?

hello Greg, thanks for your diligence and approval. We are now set. Thanks again Joe Gibbons. N200D

Ed, there is no offset in the engine mount or a trim tab on the rudder to deal with significant P-factor when you rotate with a 520 or 550. You have to somewhat snatch it into ground effect and throw in a lot of right rudder as you keep it aligned with the runway as you retract gear and take off flaps. A lot happening in a short amount of time.…[Read more]

Ashley-what’s the price??

Hello Thomas. There are so few of us that I doubt that anyone will do an STC, but the 337 process is moving along nicely after Peter. 2 more 200’s are currently being upgraded at Stein Air as I type. I am in line right behind them and hope to have her back with a shiny new GFC500 and twin GI275s for Christmas.

Here in Europe there are a lot of short grass runways.
Getting the Meyers down is easy in my opinion.
Takeoff performance depends on the usual factors: actual mass, wind and temperature. I have a IO 520, so power could be better. To get best climb out you need to fly with Vx over the trees and then accelerate to Vy while cleaning up. I find it…[Read more]

Any news on doing an STC for the GFC500?

My Brittain B4 would like to retire…

Thomas

I would fly with the F33 guy and watch his technique. Meyers has less wing area (at least I think it does), but engine and airframe configuration are very similar. For sure see his weight limitations. At gross the Meyers will sink unless you have power in and the flare happens quickly.

Best-

Ed

Ed, a very good ask. What are your typical winds and how is the turf? My experience (and there are many folks here with much more than mine) is that short field can be tricky as you almost have to get behind the power curve to drop a 200 in. Full flaps and 90 MPH means a fair amount of power as you come down to short final to keep the sink rate…[Read more]

Jeff, glad to hear the Restoration is complete. If the rigging was done according to the manual, that is, it has the correct dihedral in the upper wing and all the control surfaces are set per the manual the only thing left is to make sure all wires are properly tightened and go fly it to see how it worked out. May need to adjust the trailing edge…[Read more]

Thank you Mark! We look forward to seeing you.

Steve-have you looked for a Micco? Might be easier to find than a 145. I know of one here in NC.