Friends – Activity – Ed Pulliam – Meyers Aircraft Owners Association

Thomas Kube replied to the topic Broken throttle cable preventer in the forum Engine – Meyers 200 7 years, 9 months ago

Hi,
I am looking for the same install.
Can anybody post a picture of the spring and its installation points?

Thank you.

Thomas
Thomas Kube replied to the topic Landing lights glasses in the forum Airframe – Meyers 200 7 years, 9 months ago

We found a ‚replacement‘ and could help out if someone wants some spare.

Thomas
Mark Jensen replied to the topic Meyers performance in the forum Engine – Meyers 200 7 years, 9 months ago

Sorry, I meant GAMI fuel injectors.
Mark Jensen replied to the topic Meyers performance in the forum Engine – Meyers 200 7 years, 9 months ago

My 200 has a IO 520 engine. I normally cruise with fuel setting LOP. I have a EDM 700 installed so I can see exactly when I reach peak and GAMI plugs installed so all cylinders peak close to the same tempratures. I think this equipment is important for lean of peak operation. I continue to adjust lean of peak until I fell rougness in the…[Read more]
John Secord replied to the topic Meyers performance in the forum Engine – Meyers 200 7 years, 10 months ago

My 200C which I also race has the IO-520A with Gami’s and setup to cruise at 2350 RPM and what ever MP I can get which is obviously dependent on Altitude and other. Also run ROP. On average though, I cruise at 9 – 10,000 ft and avg. 21″MP @ 2350 @ 14 GPH which typically gives me around 186KTS True Airspeed. CHT’s are generally around 350 and EGT…[Read more]
Richard E Russell and Oliver Wallace are now friends 7 years, 10 months ago
Thomas Kube replied to the topic Meyers performance in the forum Engine – Meyers 200 7 years, 10 months ago

I have a 520a.
Here in Germany 100LL is about 8$/gal, so we try to run LOP.

With my very limited experience with my plane I just did 1 longer trip of 3hr 45 min to France. In FL 85 she took 12,5 gal/h for 140kn GS. Therhe must be some improvement.

When she is back from the shop I will go for max speed ROP, Christmas is coming…

Any more…[Read more]
Thomas Kube started the topic Meyers performance in the forum Engine – Meyers 200 7 years, 10 months ago

Question from a newbie: How do you run your engine to get

a) The best speed(max power) in low and high altitude?
b) the best economy (ROP or LOP)

Doe someone have a scheme for power setting in different altitudes like some other types of POH provide or do you go by CHT and EGT.

What are you racers seeing on fuel burn on a typical race.

Thomas
Steve Bauman and Thomas Kube are now friends 7 years, 10 months ago
Richard E Russell replied to the topic Reasonable Crosswind Limitations for an OTW on pavement? in the forum Airframe – Meyers OTW 7 years, 10 months ago

All: Regarding OTW landings, grass, hard surface runways and crosswinds – FAA certification of Part 23 (OTW were certified under CAR 4, the previous certification standard before FAR Part 23) is 15 mph ‘demonstrated cross wind’. Factory test pilots are required to certify all Part 23 airplanes to 15 mph crosswinds, therefore, it then depends upon…[Read more]
Richard E Russell posted an update 7 years, 10 months ago

@oliverwallace : are you interested in my airplane?
- Oliver Wallace replied 7 years, 10 months ago
  
  Hi Richard,
  
  Yes I am!
  
  I’m interested in purchasing a Meyers OTW in early December should I get a place on the Vintage Air Rally 2018 which is by no means a certainty, but I am planning on an optimistic basis!
  
  We get notified on the 1st December and so if successful then I would be looking to purchase one in December of this year. I would also…[Read more]
Thomas Kube started the topic Landing lights glasses in the forum Airframe – Meyers 200 7 years, 10 months ago

Hi,
While dismantling the cowling for new paint we found the glasses broken.

Does anybody know of a source to get spares?
I send Joan already a message…

Thanks,

Thomas
Thomas Kube replied to the topic Introduction and advice needed in the forum General- Meyers 200 7 years, 10 months ago

Hi,

I am in Florida at the moment an thinking about essentials for the Meyers to take home.
I asked globalparts to offer a set of landing gear bushings.
What else do you recommend to have in the parts-box?

Thanks,

Thomas
Steve Bauman and Mark Jensen are now friends 7 years, 10 months ago
Thomas Kube replied to the topic Window and windshield 200D in the forum Airframe – Meyers 200 7 years, 10 months ago

Hi,

Does anybody know if the air Kool scoop vent from various shops fit in the pilot side window?

Would be nice for summer and taxi.

Thomas.
John Secord and Ed Pulliam are now friends 7 years, 11 months ago
John Secord and Ed Pulliam are now friends 7 years, 11 months ago
Mark Jensen replied to the topic Seats for 200D in the forum Interiors – Meyers 200 7 years, 11 months ago

I have fiberglass front seats but I need rear seats. Does anyone know of a source?

Mark
Mark Jensen replied to the topic hydraulic pressure in the forum Hydraulic System – Meyers 200 7 years, 11 months ago

Joan Diver was also able to provide a new spring. Problem solved.
Richard E Russell and Jeffrey Wheeler are now friends 7 years, 11 months ago
Load More