Karen Wade

Hello Thomas. There are so few of us that I doubt that anyone will do an STC, but the 337 process is moving along nicely after Peter. 2 more 200’s are currently being upgraded at Stein Air as I type. I am in line right behind them and hope to have her back with a shiny new GFC500 and twin GI275s for Christmas.

Jeff, glad to hear the Restoration is complete. If the rigging was done according to the manual, that is, it has the correct dihedral in the upper wing and all the control surfaces are set per the manual the only thing left is to make sure all wires are properly tightened and go fly it to see how it worked out. May need to adjust the trailing edge…[Read more]

Gary,

The high pressure seal double seal I mentioned above is actually called an O-ring loaded U-cup seal. It is a harder rubber up with a softer O-ring inserted to push the cup against the shaft. The McMaster part number is 9505K15. I believe this is the seal that was in my flap selector and gear valves, but the harder rubber cup was…[Read more]

Gary,

Here are the O-ring part numbers for each of the M200 gear and the flap actuators:

3 each AN6227B-17 (MS28775-212)
1 each AN6227B-10 (MS28775-112)

The flap and landing gear selector valve use the following seals
2 each MS2775-117
1 each 1161N52-204 . (They also have a reinforced high pressure double O-ring type seal, but it is a harder…[Read more]

Gary,
I am currently on vacation and won’t be at my hangar until Labor Day weekend. I sent Robert Whitfield a complete set of seals, so he should have the part numbers. All are common O-rings available thru Aircraft Spruce, except the internal gear handle valve and flap selector valve. I found a compatible seal at McMaster Carr that is working f…[Read more]

Some other owners contacted me and said my response was not as friendly as it should have been. My apologies.

Which airplane on the For Sale site is sold?

Which one are you saying that’s from 2019 and isn’t currently owned by them anymore?

The listings are only as good as the people posting them. If the owner doesn’t let us know that it’s sold, it’ll just remain there.

Remember, this isn’t some big fancy company with many employees. It’s a small group of owners of a very small population of aircraft.

Jim Jones and Mike Barg at the Meyers OTW repair Center in South Carolina can help. You can reach them on the site by searching in the members directory. We’ll all be at the fly in next month in Fredericksburg, TX next month and that would be your very best bet. There are 5 OTWs in planned attendance. As long as your Kinner parts don’t have…[Read more]

Ed,

I’ve been told they may be rechromed without creating any issues. Please contact Ross Warner to see about finding new old stock parts. He may be able to point you to someone who knows where to find them if you decide to go that route.

VR, Tom

Ray,

So very happy to hear the damage was minimal given your scenario. Thank you for the additional information. I’m guessing the strut extended slightly once the gear was in the well to force the tire against the bail and cause it to bind. A very unusual situation to be certain.

You did an excellent 2 wheel landing and had a great outcome.…[Read more]