@markyoung
-
Tony Parsons replied to the topic Annual Checklist in the forum Meyers 200 1 year ago
Send me your email and I will send to you
-
Gary Harber replied to the topic Yoke leather wrap in the forum Restoration / Rebuilding – Meyers 200 1 year, 1 month ago
Actually, I think I found one that matches my yoke:
-
Gary Harber replied to the topic Yoke leather wrap in the forum Restoration / Rebuilding – Meyers 200 1 year, 1 month ago
Let me know if you find anything that works and looks good
-
Steve Bauman replied to the topic Interior Lighting in the forum Interiors – Meyers 200 1 year, 1 month ago
Kevin
Please send me your EMAIL ADDRESS will send you pictures of N2960T when Susan OLIVER had the airplane
STEVE BAUMAN-
Steve, if you didn’t receive my email, my address’s is: Kevin_mcginty@me.com
-
-
Steve Bauman replied to the topic Interior Lighting in the forum Interiors – Meyers 200 1 year, 1 month ago
Kevin
STEVE BAUMAN -here– N2989T–Your airplane was SUSAN OLIVERS’S airplane N2960T. It had the blue two tone paint scheme. Would you want to go back to the original “N” number?
Steve -
John Secord's profile was updated 1 year, 1 month ago
-
Tony Parsons and
Joseph McDonald are now friends 1 year, 2 months ago
-
Tony Parsons started the topic Fuel Sender Unit in the forum Engine – Meyers 200 1 year, 2 months ago
I am needing to replace fuel floats/sender units. Has anyone done this? I have a part number for A/C delco part but has anyone replaced them with anything else? Part number? Where did you buy. Thanks!
-
Ross Warner replied to the topic Interior Lighting in the forum Interiors – Meyers 200 1 year, 3 months ago
I’ll forward a picture next time I’m at the hangar. pass on a cell number for a text photo. Ross
-
Ross Warner replied to the topic Interior Lighting in the forum Interiors – Meyers 200 1 year, 3 months ago
Keven, the glare shield is most definitely the overhang of the dashboard. The white lights would be mounted under to illuminate everything below in white light. They may have been removed by a previous owner? Hopes this helps. Ross
-
Ross Warner replied to the topic Interior Lighting in the forum Interiors – Meyers 200 1 year, 3 months ago
Hello Kevin. The second position for your panel light controls white light bulbs (four?) under the glare shield. Your bulbs may be burned out or a power wire detached. Ross
-
Ross Warner replied to the topic Oshkosh 2024 in the forum General- Meyers 200 1 year, 3 months ago
Ross and Son, Ross IV always attend and plan on early arrival on the 18th. We also have set up a Meyers group dinner at Wendt’s on the lake on Tuesday again, as you know. Should have several Meyers in attendance. Looking forward to seeing you all again. Ross
-
Tony Parsons and
Gary Harber are now friends 1 year, 3 months ago -
J. Brent Stabler and
Gary Harber are now friends 1 year, 3 months ago -
Chris Blaine and
Kent Aitchison are now friends 1 year, 3 months ago
-
Tony Parsons and
-
Tony Parsons and
Ross Warner are now friends 1 year, 4 months ago
-
Tony Parsons and
Steve Bauman are now friends 1 year, 4 months ago
-
Tony Parsons replied to the topic High CHT #6 in the forum Engine – Meyers 200 1 year, 4 months ago
Hi Everyone! Newbie just now able to get on the site. I am having the same issue as Thomas. #6 is getting up to 430 on takeoff climb now that it is getting hot, 90 degrees. In cruise, all are under 380. I am at 400ft MSL, full rich, fuel flow is almost to redline, cowl flaps wide open. Injector is clear, AP says baffeling is fine. Bore…[Read more]
-
Tony Parsons and
Mark Young are now friends 1 year, 4 months ago
- Load More
