Ed Pulliam

Thanks Dennis, I’m tardy in my reply. I think both Garmin and Avidyne are quite expensive in the repair/flat rate repair department. I much prefer the Avidyne overall, but it seems so few shops (that I have had contact with) will recommend or even want to sell them. Garmin definitely has the grips on the business, and I guess some folks should…[Read more]

To Ashley, and others that have done “the Mod”. Not many comments after the installations, I am hopeful for some reports from the others that have done it. How long waited, how much $$, how satisfied, any regrets/wishing for another system, etc? Just finally getting to some avionics improvements on mine, the stuff Ashley mentioned is mostly…[Read more]

Update: some tweaking of the idle mixture and the engine runs fine. Take off fuel flow ist 28,3 gal/h resulting in good temperatures and performance „as expected“ by us. Annual done and the weather is also improving.

Keep on flying them birds!

Thomas

Update: had another cylinder overhauled and all rotocaps replaced. On Runup the fuelflow was well below spec. Had the fuel control unit overhauled here in Germany. Came back with factory settings. On run-up engine stalls below 1500 rpm. Need to setup the FCU according to SB. Did anybody venture this way before and has some knowledge to share?
I…[Read more]

We adjusted low Pitch stop to maximum but no RPM rise. The linkage itself is quite simple to a adjust, but that is not the problem. I will measure the low pitch angle to check for a wear of the propeller. Last overhaul was 2009 and last maintenance was 2020, lubricaction of the hub.

A month before my Mitchell tach showed a malfunction, an…[Read more]

Hi Ed, do you see the hole in my foot? I almost shot me one…
No STC for our airplanes and no EASA Approval either. I will have to have him overhauled.

Thanks for pointing my nose to this minor bureaucratic problem…

Thomas.

Hi Dennis, I recently flew a friend’s c310 with IFD540/440 and really liked them. They seem much more user friendly and so simple to operate. I was ready to jump on them when he had an issue and the avionics shop had to send his 540 back to FL somewhere. He waited many weeks for the repair and it was not inexpensive. SEA is a giant aviation…[Read more]

Hi guys
The flight controls on the Meyers 200 do NOT need to be balanced when painted. They are controlled by push –pull rods. Aircraft that have control CABLES they are the ones that need to be balanced if painted.
This from the FAA.
Steve Bauman

Also on ANOTHER change to the IO550-F engine is the 2 bladed prop on the IO520-A is 82 inches, the IO550-F engine requires a 2 bladed prop to be 84 inches.

Hi Ed,

I found the upper intake mount bracket broken on my plane. Caused some vibration. Fixed it but now we chase other problems, like a leaking F&M adapter and a leaking valve cover.

Keep the spirit up.
Thomas

HI from Germany, I have the same problem. No significant leakage but still a mess after flight.
We will try again and report.
Thomas